- 본체 내부 직경
- 1.3550 inches minimum and 1.3600 inches maximum
- 본체 외경
- 1.5020 inches minimum and 1.5030 inches maximum
- 모서리 모양
- chamfered outside right corner
- 모서리 모양
- chamfered inside left corner
- 모서리 모양
- chamfered inside right corner
- 모서리 모양
- square left flange body corner
- 모서리 모양
- square left flange outside right corner
- 모서리 모양
- square outside left corner
- 플랜지 외경
- 2.0000 inches nominal
- 플랜지 폭
- 0.0750 inches minimum and 0.0800 inches maximum
- 전체 길이
- 0.6200 inches minimum and 0.6350 inches maximum
- 재료 문서 및 분류
- ams 5643,17-4 ph assn std single material response overall
- 재료
- steel comp 630 overall
- 스타일 지정자
- solid, external flange one end
- 표면 마감
- 125.0 microinches inside diameter surface of body
- 표면 마감
- 125.0 microinches outside diameter surface of flange
- 표면 마감
- 125.0 microinches left end surface of body and flange
- 표면 마감
- 125.0 microinches right end surface of body
- 표면 마감
- 125.0 microinches right end surface of left flange
- 표면 마감
- 32.0 microinches outside diameter surface of body
- 표면 처리 문서 및 분류
- f-t402,fscm 77751 mfr ref single treatment response or z-r901 sz,fscm 77751 mfr ref single treatment response overall
- 표면 처리
- cadmium and titanium or passivate overall
- 테스트 데이터 문서
- "81349-mil-i-6868 specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.)."
